Jump to content
Fencer-1

1/32 A.M.U.R. Bf 109G-10 Erla corrected nose section test run.

Recommended Posts

That is some damn nice modelling and detailing.

 

Why the indented, and not scribed, hand-holds?

 

Tell me about the angled rivetting on the boss, and the rivetting at the gun orifice.  I haven't seen that before.  Where did you find that info?

 

Many thanks.

Sincerely,

Mark

Share this post


Link to post
Share on other sites

That is some damn nice modelling and detailing.

 

Why the indented, and not scribed, hand-holds?

 

Tell me about the angled rivetting on the boss, and the rivetting at the gun orifice.  I haven't seen that before.  Where did you find that info?

 

Many thanks.

Sincerely,

Mark

Hello, Mark!

There are pre-production details, so they will be enhanced in production run.

Concerning the prop boss - I have some good reference photos, where these details are visible. Small rivets very subtile are almost invisible. They need to keep inner stiffeners. They may have slightly less angle on real thing than I've done. 

All 109 spinners have four screws around gun opening and some of spinners have additional ring here, as Revell made on original detail. 

 

Thank you,

 

Alex.

Edited by Fencer-1

Share this post


Link to post
Share on other sites

looks beautiful!

 

on another note, did you not say you were looking at replacement external bomb racks for the Revell He111 H-6?

 

or was that not you?

 

(oops!)

 

:)

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...