The Rex was boring me to tears. But most of all I was greatly inspired by Dannys' (Vandy 1 VX 4) PT 365 conversion. Found here: http://forum.largesc...ic=61120&page=1
New flag staff from Albion Alloys brass telescoping tube. Cap is melted rod. Light is clear sprue. New Hatch Dogs.
Reworked Smoke Discharger.
Reworked Roll-Off Rack. Right side. Re-discovered the adhesive qualities of masking fluid. I used masking fluid as an adhesive to connect the bars and rods of the mechanism. This held them together while I installed the assembly. Silver is flattened solder as fasteners.
Vent. White rod is supposed to represent a winged bolt. Flattened solder fasteners.
Rear turret. Bolt fasteners. Blanked in rear wall. I see I forgot to clean up the ammo rollers. Oh well. Dinghy: new Gunnel, Chine, Rudder Board?, straps and fasteners.
New Hatch Dogs, Antenna Base, Running Light Guard. White strip to correct a mistake.
Detailed 20mm Gun. Removed Barrel, drilled out Recoil Housing, located solder as Recoil Spring, handles on Ammo Container, misc. details. Ammo Container base for Container sets on Ammo Storage Box Hatch Dogs. Penciling are notes concerning Camber, Bulkhead location, and Deck Line.
Reworked 37mm. Hatch Dogs.
Handles and Trigger. Or it's supposed to be.
Reworked Rocket Launcher.
Other side. More pencil notes in background.
Front Turret. Turret Ring Fasteners, blanked in opening, new Flooring. On the Day Cabin in the background: Hatch Dogs, Cabling, Brass Rail to the top, Boat Hook Shaft toward the bottom.
Edited by dodgem37, 24 June 2017 - 06:36 PM.