Jump to content

Lemkits 1/32 Ilyushin Il-10 " Beast " – Limited edition resin kit - on sale


Recommended Posts

Very clean and nice build :goodjob:

 

How did you attach the wings to the fuselage? The wings are hollow, so there is only a small contact area for the glue. I have concerns about the rigidity of that joint over times.  Did you somewhere add some kind of a wingspar or wire pins?

 

Regards

- dutik

Link to post
Share on other sites
On 11/25/2020 at 6:57 PM, dutik said:

Very clean and nice build :goodjob:

 

How did you attach the wings to the fuselage? The wings are hollow, so there is only a small contact area for the glue. I have concerns about the rigidity of that joint over times.  Did you somewhere add some kind of a wingspar or wire pins?

thanks), just glued, when using high-quality CA and technology, you can't tear it off. Well, considering that the assembled model weighs only 240 grams, that's enough.
To be sure, you can add some elements screwed to the end rib on the fuselage parts, which will go into the wing cavity.

Edited by upor
Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...