Aladdin model ?

[red Dog]

Any one have any experience with these guys? 

 

https://www.aladdinmodel.com/product-page/detail-set-for-trumpeter-02272-1-32-f-8e-crusader

 

Been searching for a intake replacement for my next F-8 project. Wonder what is the quality of their stl and if their model comes presupported or not. 
I'll probably ask before buying but if you guys have experience dealing with them, I'd be happy to know

 

Thanks

[LSP_Kevin]

Just be aware that Aladdin Model is a site for hosting STL files from a range of vendors, so they could come from anyone. Their website is a little unclear about that, but their Facebook page makes it obvious. They also recently rebranded to Aladdin Models from Print Replica.

 

Kev

[red Dog]

Thanks Kev,
Yes I realised that browsing further on their site . The F-8 intake is actually the one which was developped by NE resin and shown here on LSP

 

 

[Madelf75]

On 4/13/2025 at 10:50 AM, red Dog said:

Any one have any experience with these guys? 

 

https://www.aladdinmodel.com/product-page/detail-set-for-trumpeter-02272-1-32-f-8e-crusader

 

Been searching for a intake replacement for my next F-8 project. Wonder what is the quality of their stl and if their model comes presupported or not. 
I'll probably ask before buying but if you guys have experience dealing with them, I'd be happy to know

 

Thanks

The intake for the F-8 are the ones that I made 

 

[red Dog]

Thanks Madelf for your input.

I figured it out.
I was under the impression (I might be wrong) that you had some troubles at the later stage of designing this so I was wondering if you overcame these issues and if the part was good to be ordered?

[Hubert Boillot]

I’m a happy customer

 

 

I do not know about the F8 intake, but the figures I bought were sent as .ctb files tailored for my 3D-printer.

 

Hubert

 

[Madelf75]

On 5/6/2025 at 10:27 AM, red Dog said:

Thanks Madelf for your input.

I figured it out.
I was under the impression (I might be wrong) that you had some troubles at the later stage of designing this so I was wondering if you overcame these issues and if the part was good to be ordered?

The issue that I am having is when I print something on my S4U that is over 3 inch long I get some really bad layer lines but I think I got it fiber out but I have been busy working on some other stuff that I just haven't got back to it 

1/32 A-6A cockpit for the Trumpeter kit