Jump to content
Sign in to follow this  
Zactoman

1/32 Phoenix pallet correction for Trumpeter F-14s

Recommended Posts

Now available from https://zactomodels.com/

Designed to fit the Trumpeter 1/32 F-14 kits.

Though these parts look very similar to the kits parts, if you look carefully, there is a difference:

Pallet_1_zpsldr7mbcv.jpg

Rather than replace the whole pallet, which would be expensive, I decided to just replace the most offensive part. While the detail Trumpeter provides on the rear portion isn't the most accurate :rolleyes:, it does look good with paint and a wash and not that difficult for the modeler to improve if so desired. 

 

Pallet2_zpsimr6pf1p.jpg

 

Again, you have to really look close...

Pallet3_zpswpgnr4rq.jpg

 

:beer:

Share this post


Link to post
Share on other sites

Thanks for the nice comments! :rolleyes:

 

Taking a suggestion from the pallet thread in the "LSP Discussion" forum, I'm now shipping these in padded envelopes (bubble lined) and have slashed the S&H cost.

International S&H reduced from $14.75 to $7.50 (Canadians can e-mail me for an additional $0.75 discount).

U.S. rate reduced from $4.10 to $1.75.

Combined shipping (of pallets only) is possible using these padded envelopes. I can fit up to 6 sets and S&H only goes up slightly.

 

:beer:

Share this post


Link to post
Share on other sites
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...