Help needed, those with an Infinity Val kit

[seiran01]

If someone here has the Val kit in hand and also has a good set of calipers, I need your help please.

 

I’m finishing up a detailed prop hub design which will go over to Barracuda for production when completed, this is to replace the crappy kit hub. The design is essentially finished but since I don’t own the kit, what I need help with is one of you confirming the diameter of the prop shaft in millimeters, and also the diameter and depth of the mounting holes for the prop blades. 
 

Huge thanks to anyone who can assist,

Mike

[denders]

Mike,

 

I don't have a caliper in mm, but I get the following using 25.4mm per inch to convert.

 

Diameter of prop shaft 0.095" = 2.413mm

Prop mounting holes Depth 0.075" = 1.905 mm

Prop mounting holes Diameter 0.102" = 2.591mm

 

Dave

 

EDIT: I had mistakenly swapped the mounting hole dimensions.

 

Edited June 15, 2023 by denders
Corrections

[seiran01]

Beauty! Thanks so much Dave!