Search the Community
Showing results for tags 'hun'.
Found 1 result
Ooooh-hoooo I've somehow ended up with a good bit of aftermarket for this build! That's what brought it to the forefront for my next project. I've just found individual pieces for it cheap over the years and so I decided to go ahead and get the rest that's available for it. Check out the treasure chest I've amassed - From Eduard I've got the self-adhesive placards, slats, air brake, undercarriage, and wheel well sets. For cockpit choice I've got both the Verlinden and the Aires sets to work from. The Aires set I picked up at Nationals a few years ago. last day, last hour and they had the whole table 50% off. Couldn't pass it up. The aires set has canopy and wheel well upgrades in addition to the engine details. It looks pretty good. Honestly I don't know which cockpit tub I'll go with as they both look crisp. Will have to check accuracy for my bird and make a decision. Thats a master Pitot tube in there along with the Zacto nose enhancement for a facelift. Then lastly I was looking at all the Eduard pieces and just didn't like the fuselage PE they had. It all sticks off the surface too much. That's when I remembered seeing an email about Archer Fine Transfers announcing a new sheet. I used their hatches, hinges, and other resin bits on my T-38A and now they have redone the sheet at 1/2 the thickness of the original. This should do perfectly for the access hatches, fuel doors and the like on this AC. I'll post details up on this as soon as possible. I don't think I've seen a review on them yet. There's been alot of these Huns done and I think I have every one of them on a separate tab on my ipad for review as I get going. Given that, I plan to post fewer mid-term updates as most people have seen it all on these. I'll try sticking to the finished assemblies and just post up some details on the new stuff, like the Archer panels and the foiling, especially the Titanium tail and the archetypical bluing and burnt metal look they have!