Wackyracer Posted January 20, 2017 Author Share Posted January 20, 2017 So here's a little secret. Whilst trying to clean up the control stick I managed to break it and the top section got eat by the carpet monster. Luckily I had another Fly Hurricane with the IIC so grabbed that one as a replacement. Now I had 2 kits and 1 stick so best see what I could find... Grey Matter have just the thing so got 2 sets of their replacement sets. The seat was much nicer also So original seat and control stick replaced. And set about adding the PE and resin to the side walls Installed the exhaust housing blanks and bumps. Did some test fitting of the fuselage and cockpit and with a bit of forward planning on what and when to glue should all go in OK. Oh another instruction cockup sees no refs for the exhaust plates. A matter to look around the sprue's and see what looks like the parts. Also the instructions show rivets and details but the parts and PE have nothing! Aaron tucohoward and dennismcc 2 Link to comment Share on other sites More sharing options...
dodgem37 Posted January 20, 2017 Share Posted January 20, 2017 Nice start. Sincerely, Mark Wackyracer 1 Link to comment Share on other sites More sharing options...
Guest Peterpools Posted January 20, 2017 Share Posted January 20, 2017 Aaron Nice save for sure. Very nce start on the front office. Keep 'em coming Peter Link to comment Share on other sites More sharing options...
LSP_Kevin Posted January 20, 2017 Share Posted January 20, 2017 Good work, Aaron. Kev Wackyracer 1 Link to comment Share on other sites More sharing options...
Joel_W Posted January 20, 2017 Share Posted January 20, 2017 Aaron, Not only was it a great save with the Gray Matter replacements, but the new parts looks so much better. Looking forward to your next update. Joel Link to comment Share on other sites More sharing options...
Wackyracer Posted January 22, 2017 Author Share Posted January 22, 2017 After the upgrade with the seat and stick I found the thread on here from Quang with his excellent Spinning Wild build. and have since ordered a Yahu instrument panel from the big H. Should be here tomorrow, so the pit is on hold and I turned to the wings These turned to a few hours wrestling match to get the resin landing lights to fit and the wings to close up. I also found out the port wing under side was about 1mm longer at the tip than the top so after the glue had dried a lot of fettling was required to bring it back to the top and maintain a thin edge After that I took another hour or so taking the pour block off the undercarriage bay. And fitting in place whilst checking I had sufficient clearance with the fuselage. Aaron Cees Broere, tucohoward, MikeMaben and 1 other 4 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now