Jump to content

1/32 F-35A TAILS, EXHAUST, FLAPS sets


CruZz

Recommended Posts

Wow, those parts look excellent Cruzz!      What is wrong with the OOB empennage out of curiosity? 

Hello gents!

 

Problem of the kit parts is here.... fitting of parts isn´t good and surface is tragic. And is very hard to putty the gap correctly because of RAM panels.

I will send you photo of parts on the kit, in few days. 

And the PE Exhaust is amazing. I have it at home too.

So I sand the surface and made a new RAM panels.

IMG_20180313_205438%202_zpsfmbdzjbg.jpg

065_zpsnjdqtyfj.jpg

Edited by CruZz
Link to comment
Share on other sites

That generally looks nice but the AB section looks split down the middle so looks like there would be an impossible to remove seam...

 

 

You might be surprised. Ive used several different PE exhaust can sets, and the way the PE is designed is to minimize the appearance of any seams between PE sheets like the can. I found that it was sometimes almost impossible to see the seam if the PE was done right. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...