Jump to content

Flying Leathernecks 3D Printed F/A-18A/A+ Tail Stiffening Plates

Dave Roof

Recommended Posts

After a few test prints and adjustments to the CAD, I was able to get successful prints of the vertical tail stiffening plates found on the F/A-18A/A+. In 1/32 scale, the plates are .49mm (.0190") thick and in 1/48 scale, they are .32mm (.0125") thick. 


Visible are all of the rivet/screw fasteners. In addition to these, F-16 Fuselage Plates and the Belly Strap for the F-4E/G/J(UK) will be released in late April or early May after we complete our move to Temple, GA. 


Product numbers and prices will be assigned and set at that time. 





Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...