Jump to content

Special Hobby 1:32 He100D


Rick K
 Share

Recommended Posts

A few weeks to simmer after the A29 Super Tucano finish then sorting through and thinning my stash I cleaned my bench and started another project.  I was leaning towards a WNW or Tamiya kit.  You know, those kits with exquisite engineering?  Nope!

 

Instead it's another short run project with plenty of challenges. 

 

Special Hobby He100D.  Why?  I love the story behind this aircraft.  Fast with beautiful lines.  Beating out Willys 109 in all categories except the political one. 

 

This will be a "what if" build with late 1945 scheme with a WGr.21 loadout, perhaps a He100G3 designation or He113D6.  Also this a/c will have no internal evaporating system.

 

176622C5-900E-4AAA-BDB7-0927CDA18FA5_1_2

 

Fun with things resin.  Cut and sand...it's a beautiful thing.

IMG_0621.jpeg

 

IMG_0620.jpeg

 

Template used to assign launcher mount holes marked and drilled out.

IMG_0619.jpeg

 

Stepping out of my comfort zone I'm going to rivet entire a/c.  Starting with the upper wings the Pounce Wheel(s) are put to work.

Wing_Starboard_Rivet.jpeg

 

 

Link to comment
Share on other sites

Lower wing gets some Pounce love.

 

Lower_Wing_Rivet.jpeg

Lower wing riveting complete.  The landing flaps (top and bottom) are rendered as being fabric.  Will have to remove the "ribs".

 

Wing_Starboard_LandingFlap.02.jpeg

Sanding becomes somewhat futile as the ribs are deep and sanding them down presents an uneven surface. 

 

Wing_Starboard_LandingFlap.03.jpeg

3M Acryl Red Glazing Putty thinned with Mr. Leveling Thinner is applied with a brush.  After cure sanding yields the even surface I'm looking for.

 

 

Link to comment
Share on other sites

Interesting construction site I would love to see. You rolled rivets, I have a question if there are drawings of the Нe-100 with rivets? I have not found them in any of the known monographs. If you have any, please share. I have plans to build this airplane as well. 

Link to comment
Share on other sites

6 hours ago, Citadelgrad said:

I saw this at a recent kit exchange, i was wary of the limited run and my limited skills. Looks like you have it well under control. I will watch his with interest. 

Not sure if under control as of yet.  Many steps to proceed and successfully complete before I call this under control.  The cockpit, the wing cannon, the landing gear all will receive plenty of attention.  At any point this could go downhill fast and end up in the 86 tub.

 

Test fitting the wings and fuselage this weekend.  You may hear the screams.

Edited by Rick K
Link to comment
Share on other sites

On 9/16/2022 at 1:49 PM, Sasha As said:

Interesting construction site I would love to see. You rolled rivets, I have a question if there are drawings of the Нe-100 with rivets? I have not found them in any of the known monographs. If you have any, please share. I have plans to build this airplane as well. 

Hi Sasha.  No reference for rivet pattern.  I used rivet detail on several Luftwaffe planes such as Fw190 and Bf109 and used reasonable assumption.  I guarantee you the probability of accuracy is low.

Edited by Rick K
Link to comment
Share on other sites

Very interesting project, Rick.

 

I came along with a similiar "what-if" when reading that a lot of Spitfire and Hurricane pilots reported of fighting the He 100´s and even claimed several victories over them. So, what would have a He 100 looked like when fighting during the Battle of Britain?

Finished my He 100 some months ago and wanted to post some pics for weeks now, but now I´m not sure, if I would "catch" your thread?

 

Reimund

Link to comment
Share on other sites

7 hours ago, scvrobeson said:

Looks like some spreaders in the fuselage will be needed to get those trenches to close.  Wonder if the floor will be wide enough to solve it?

 

 

 

Matt 

TBD if the cockpit will spread fuselage at wing root. 

 

There will be a spreader placed top of fuselage to accommodate the wide canopy.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...