Jump to content

1/32 MiG-23BN Upgrade Parts

Recommended Posts

At long last I finally have the MiG-23BN parts in hand!  The bulged nose gear doors, Delta-N pod, and main IP are 3D printed using a very high end printer that lays down 5 micron layers.  You can feel the slightest bit of surface roughness, that I suspect will disappear under a coat of paint or a swipe with some 600 grit paper.  The main IP instruments were film printed by Eduard for me.  Cost on this is US$ 25.  I'll pick up postage in the US (anywhere with a Zip Code), but for outside the US, please add $4 for shipping.


Note that I only got 8 sets of the 3D printed stuff done, and I'm keeping one set, so only 7 sets are currently available.  I have plenty of the instrument films, but if there's more demand than 7 sets, I'll need to get more 3D printed stuff done, which will take a while.  So for now, it's first come, first served.  


Paypal to jrheilig01 at gmail dot com





Bulged nose gear doors...




Delta-N pod...




Main IP...




Instrument film...



Edited by Jennings Heilig
Link to post
Share on other sites
  • 1 month later...
  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...