Jump to content
Cap'n Wannabe

Matchbox 1/32 Westland Lysander: I have made progress

Recommended Posts

Some more progress....not much, but I have been extremely busy of late!

 

The engine primed..

 

EpueETBl.jpg

 

..and painting started.  It took me a while to figure out the best way to paint the engine - most photos I've seen have the crankcase black, as well as the rods that go up the front of the cylinders, whereas the cylinders themselves are aluminium.  I've only done the back of the cylinders so far, and I think once I apply a wash, it'll look pretty good.  (Actually, I reckon it don't look half bad in the photo..)

 

gXT4F6Ml.jpg

Share this post


Link to post
Share on other sites
On 9/15/2019 at 12:50 AM, TwoHands said:

I have been looking for photos of the upper wing surfaces.

 

I took these photos from the observation deck at the Canadian Warplane Heritage Museum. Hope they help, you should be able to click on theimage and enlarge them if you need a closer look:

 

FJSMwduh.jpg

 

qS1bmxLh.jpg

 

YhcsEPmh.jpg

Some canopy detail:

8cVqkqCh.jpg

 

TyEGA1ch.jpg

 

Richard

Edited by R Palimaka

Share this post


Link to post
Share on other sites

So in between my job and ICUS (In Command Under Supervision) training, and getting into the groove of instrument flying in the real world instead of a training environment (you're visual when you get clear of cloud instead of when the instructor tells you you are.....and at night....lotsa fun!), I've managed to [almost] finish painting the basic colours on the engine.  I firstly painted SMS Black as the base coat, then painted the cylinders in Tamiya Flat Aluminium....almost, but not quite dry-brushing them.  Due to the way the engine is molded, aluminium paint got into lots of places I didn't want it to be, so the next step was removing it from them.  I thought about how best to do it - I could have simply painted black over it, but that would run the risk of the aluminium showing through the black, so instead, I wet a brush with methylated spirits and carefully removed the paint.  There are still a few places I need to go over, but so far, so good..

 

GF4xNnbl.jpg

Share this post


Link to post
Share on other sites

 Love this plane! I've got three of these kits and have no excuses for not building them. Bad mojo be my enemy.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...