oyoy5 Posted April 27, 2019 Share Posted April 27, 2019 I have a Hasegawa K-4 and a Revell G-10 ERLA, not and expert and want to do AIMs markings for Red 2. Thank you for any help alanash1963 1 Link to comment Share on other sites More sharing options...
thierry laurent Posted April 28, 2019 Share Posted April 28, 2019 The K4 will ask for far less work. The Erla G10 had a completely different nose. Ideally, you should start with an Hasegawa G10 to have the minimum amount of changes to do. Hth Thierry Link to comment Share on other sites More sharing options...
thierry laurent Posted April 28, 2019 Share Posted April 28, 2019 Actually, if you like conversions and scratchbuilding, you could combine both kits to get a G6AS with less work. In any case, unless starting with an Hasegawa G10, you will have a lot of modifications to do. Link to comment Share on other sites More sharing options...
mhorina Posted April 28, 2019 Share Posted April 28, 2019 I'm just about to start on mine. As Thierry said start with Hase G-10. I am using the nose parts from the G-10 and the fuselage parts off a G-6 kit. Cutting the G-10 kit parts that would attach the G-10 fuselage off and using the fuselage cut from the G-6 kit. If you have a G-14 kit available you could use the tail parts from that . I will cut the G-10 tail off at the trestle hole and do the same with the G-6 fuselage to so as to use the tall tail fin. Or if you have a spar G-14 kit that tail could also be used, and just use the instructions from the G-6/G14 Good Luck. Or if you can get a Revell G-6 cheap you could usethe rear fuselage from that and use the Hase G-10 kit as above. Mike Horina Link to comment Share on other sites More sharing options...
oyoy5 Posted April 28, 2019 Author Share Posted April 28, 2019 Thank you for all the information. Link to comment Share on other sites More sharing options...
Rick Griewski Posted April 29, 2019 Share Posted April 29, 2019 (edited) I have an Eagle Editions resin G-10 Erla conversion you can have for postage. IIRC you need a Hasegawa G-14 kit so you get the correct spine profile and the regular tail. Oops my bad. I miss read the title of the thread. Please do what Mike says. Rick Edited April 29, 2019 by Rick Griewski Confused Link to comment Share on other sites More sharing options...
D.B. Andrus Posted April 30, 2019 Share Posted April 30, 2019 Personally, I'd wait for the AMUR Reaver conversion which is purported to be out in the not too distant future. HTH, D.B. AlanG 1 Link to comment Share on other sites More sharing options...
AlanG Posted April 30, 2019 Share Posted April 30, 2019 2 hours ago, D.B. Andrus said: Personally, I'd wait for the AMUR Reaver conversion which is purported to be out in the not too distant future. HTH, D.B. Here's hoping. I have the AIMs decal set that i'd like to make two G6/AS with Link to comment Share on other sites More sharing options...
oyoy5 Posted May 2, 2019 Author Share Posted May 2, 2019 Red 2 is a sweet airplane Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now