Jump to content
Ryan

1/32 HK B-25J Meet Miss Runyon

Recommended Posts

Thanks for the tips and pic Carl.

 

You are right, not much to be seen.

 

Ryan

Share this post


Link to post
Share on other sites

I know boring, but starting to set cockpit parts.

 

39793912713_455a97f844_b.jpgB-25J by The 3rd Placer, on Flickr

 

I'll mention one issue though, the IP center support seems longer than the outside legs. This causes a see saw effect left to right when its inserted into the locator holes at the cockpit floor.

I suspect its just a mold mismatch and the fix was to remove the center locating tab and block sand the center post until it was level.

 

Ryan

Share this post


Link to post
Share on other sites

Hey if you are into modeling like we all are, then this isnt boring!  Good start Ryan.  Its really a great kit IMHO, but I think I put a bit too much work into the interior of mine, as Carl mentioned, there is not much seen of the tail gunner position, nor much of the interior at all but the cockpit.  

Share this post


Link to post
Share on other sites

Thanks Az!

 

Still fitting cockpit together and found something that may creep up on your build of this model. Watch out for the clearance of this small forward panel, you'll need to dry fit and trim it down a little to allow the instrument panel to fit.

 

46076121854_fda682594e_b.jpgB-25J by The 3rd Placer, on Flickr

 

Ryan

 

 

 

 

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×