Jump to content
Sign in to follow this  
CruZz

1/32 F-35A tail set

Recommended Posts

Hello gentlemans. 

 

I made a new tail for 1/32 Italeri kit. Now I can make some copies. Is somebody interrested?

 

I will make some better photos thrue this week. 

 

If you are Interrested, please let me know. Thank you! 

 

 

002_zpsdx0ajp4e.jpg

 

001_zps4qrarkuh.jpg

 

003_zpspaiwoebk.jpg

Share this post


Link to post
Share on other sites
Posted (edited)

Wow, those parts look excellent Cruzz!      What is wrong with the OOB empennage out of curiosity? 

Hello gents!

 

Problem of the kit parts is here.... fitting of parts isn´t good and surface is tragic. And is very hard to putty the gap correctly because of RAM panels.

I will send you photo of parts on the kit, in few days. 

And the PE Exhaust is amazing. I have it at home too.

So I sand the surface and made a new RAM panels.

IMG_20180313_205438%202_zpsfmbdzjbg.jpg

065_zpsnjdqtyfj.jpg

Edited by CruZz

Share this post


Link to post
Share on other sites

You are right... but look what is in the kit.... 

 

That generally looks nice but the AB section looks split down the middle so looks like there would be an impossible to remove seam..

Share this post


Link to post
Share on other sites

That generally looks nice but the AB section looks split down the middle so looks like there would be an impossible to remove seam...

 

 

You might be surprised. Ive used several different PE exhaust can sets, and the way the PE is designed is to minimize the appearance of any seams between PE sheets like the can. I found that it was sometimes almost impossible to see the seam if the PE was done right. 

Share this post


Link to post
Share on other sites
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×