1/32 P.1101 at Oberammergau

[jeroenpeters]

Most of the basic shapes are there and seem to check out.

The hollow tubes on the base-plate and the side of the handle are to stick a long carrying bar in. This way the jack could be transported by either two men side by side, or one pulling and one pushing.

 

[jeroenpeters]

Drew the cradle, but left out the 'hammock', since I'll make that from masking tape. Only need to measure the exact height of the tail, in order to determine the height of the arm.

 

[jeroenpeters]

Almost ready for the details and thinking about how to divide the parts for optimal 3D printing.

 

 

[Hagar]

I just got my kit today and after watching this thread I have also ordered an engine for it. Do you sell the stl files you make? I'd be very interested in the engine mount file. Looking forward to more of your build.

James Knaus

[jeroenpeters]

4 hours ago, Hagar said:

I just got my kit today and after watching this thread I have also ordered an engine for it. Do you sell the stl files you make? I'd be very interested in the engine mount file. Looking forward to more of your build.

James Knaus

I’ll send you the Stl free of charge. Just PM me your email adress. 

[Greif8]

Awesome 3D design skills Jeroen, something I have zero talent at.  I am sure the 3D printed items will look great as well.

 

Ernest

[Hagar]

9 hours ago, jeroenpeters said:

I’ll send you the Stl free of charge. Just PM me your email adress. 

Hi, I tried sending a PM but it says you can not receive messages.

James

[jeroenpeters]

25 minutes ago, Hagar said:

Hi, I tried sending a PM but it says you can not receive messages.

James

Just mail me at jpetersprive@gmail.com

[Mal_Belford]

Cant wait to see that lifting trolley being 3D printed.

 

yaih...would easily have that in a  diorama.

[jeroenpeters]

First alclad on the interior and engine

 

[jeroenpeters]

That's the Herkules II done. I put the P.1101 on its feet as a dry fit to measure the height of the tail. About 6cm is what the Herkules should reach. As far as size of the Herkules I can only go by this photo. A Luftwaffe ground crew standing beside it and the nose of a Me163.

Alsmost ready for a first 3D print.

 

[jeroenpeters]

This actually is a pretty easy kit to build. Quite enjoyable after a few Special Hobby projects…

 

[jeroenpeters]

Ready for the first print.

[jeroenpeters]

Great stuff. Read through the manual and found the dimensions. Length and width were almost spot on!

 

[Thunnus]

Fascinating work on a very interesting subject.  And you're adding home-brewed 3D-printed enhancements on top of that!  Can't wait to see more.