WarLycan

Thanks for the suggestions. Froze the part for a bit, slid a exacto blade under the edge and twisted. It popped right off. Thanks again!

I appreciate the information. Thanks, gents!

Not sure there ever really was 1. I had read about Resin2detail may have produced 1 at one time. Hence, another. I could be wrong but that is why I'm here. To be more informed.

Hello, I recently purchased a "used" 1/32 Fisher F9F-5 Panther. Aside from the lack of assembly instructions and decal sheets, the only work done on the kit was glue the "chin" under the nose to try and turn the -5 to a -6. I apologize if this subject has been covered but I am looking for the best way to remove this "chin" piece and revert this back to a -5. So my question is, is there a safe way to unglue this resin piece from the resin body? Just too expensive a kit to destroy due to my lack of experience with resin. Thanks for any help you can provide.

I would really like to see another 1/32 B-26 Marauder.