justjim1

hi I have two questions ,1 is the grey matters conversion still available ,as I looked online and it does not appear . " I read that great wall were going to start releasing a range of P40,s would it be better to wait for these , I have a very large stash so no hurry as I think only old age and mortality may beat me to them . jim

Hi Otis I have now finished a resin nose and lower fuselage , to build an RF-4B/C/E . this can be built on the revell F-4E/F kit Or on the Tamiya F-4 E ,which requires a bit more cutting up of the host kit .please see my ebay listings . Jim .http://www.ebay.co.uk/usr/lroybrownmodels .http://www.ebay.co.uk/itm/232905658020?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649. regards

Hi guys who does belly straps for the revell phantom jim

Hi guys I want to build an RF-4B and need any pics of the cockpit especially the rear cockpit and instrument panel . any help appreciated. jim

hi tony please note no capitals in the address. jim

Hi tony I would be very interested in buying the conversions for the Phantom . This is the only post WWII airplane that I am collecting to build , as this is my all time favourite jet plane . my email is JimLeroybrown@Hotmail.co.uk .

back again guys as I need a bit of information on F4 Phantoms re the fitting of suu 23's after buying over thirty books on the phantom inc the double ugly series .I still need more info. I know from reading through several of my books I know that Phantoms mark C/D were fitted with these , single under the fuselage , and two ,one on each inner pylon , this was the most that they were allowed to carry . I have a few pics of these carrying one under the fuselage , but none carrying the blunt ended one on the wing pylons , which I want to portray. does anyone have any pics of these , and could any unit /squadron carry them as I know each could be 'loaded up' for any particular mission . any help guys ? .. regards Jim

Hi guys anyone in the uk looking to offload A Revell RF-4C phantom , the later one from the nineties , kit no 04702 . I am looking for a couple to convert to RF-4B /E. please get in touch .regards Jim

Hi guys I have now finished my next set of conversions for the Revell F4 Phantom series . I have made a set of FODS in resin and an Improved set of landing gears in white metal .see them here , at my ebay page .regards Jim. http://www.ebay.co.uk/usr/lroybrownmodels

hi guys is there going to be stockist in the UK . jim

Yes I do .http://www.ebay.co.uk/itm/232769143065?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1558.l2649 .jim

Hi Guys I have now finished my resin nose wheel bay and strut for this Phantom this can be seen on my ebay page .https://www.ebay.co.uk/usr/lroybrownmodels .regards Jim

Hi the retractable tai wheel is also available from me on my ebayshop . http://www.ebay.co.uk/usr/lroybrownmodels

Hi Thierry thanks for the link you sent my to the drawings of the Mk47 Seafire .fab I have just recently read you article on your build of the MK 47 unfortunately there was no was pics as photo bucket did no t support them . I would be grateful if you could post or sent any of your pics . as I want to be sure to get everything correct in my conversion kit .as you know good pics are few and far between . so for hijacking this post . regards Jim

the best me engine is the one made by dragon in the me 109 e can be improved by adding pipework/wires etc .