Here they Are.
The A-10 Engine Set complete. Fans can be installed left on the casting block, or if you are brave you can remove the casting block to get fully open and separate fan blades.
Here is a 3D fan we printed without the casting block.
Detailed, one piece, and indexed intake.
The Exhaust: The fan is molded in line with the engine, and is not centered when looking into the curved up nozzle.
Also included and shown int he family picture are the fuel pylons for each engine. These need to be attached to the exhaust in the pylon location where the fuel and control lines enter the engine inner pod. The exhausts are also cast so the casting block fits right into the clear inner nacelle if chose to remove the rear section and use it your build. You can can leave it out an no one can tell from the outside as the rear exhaust is supported at tree locations.
The kits are in stock and ready to go, and can be purchased here for $35, or from our E bay Store for $38. We really hope you all enjoy this set, as it is the most requested set we have offered to date.
Thanks to everyone for all of the support, criticism, and help in the past 20 months.
OF, the intakes with fans will be available separately, and they are $22. IN it you get two intakes, Two fans, and two fuel drains.
TO order direct it is the usual, just PM me or Email me at firstname.lastname@example.org with your paypal account email address and delivery info. We also take checks and MO’s from US and Canadian Customers.
Happy New Year!!!!!!
Many Thanks, Gary
Web Site: www.gtresinproducts.com
"In the beginning was the Word, and the Word was with God, and the Word was God, He was with God in the beginning. Through Him all things were made; without Him nothing was made that has been made. In Him was life, and that life was the light of men. The light shines in the darkness, but the darkness has not understood it.” John 1:1-4