Jump to content

mark31

Recommended Posts

Hello now my F-84 is comming  a end and its slowing down for paint to dry.

I havemade the disicion to make a start on thenext kit.

this one will also be foild.

 

The kit im going to use.

BILD3459_zps135256bc.jpg

 

The markings im going to use are from col.W.B.Wilmot Suwon.

some of the aftermarket only the nose ring is behind in the mail.

BILD3460_zps0f239680.jpg

 

Mark

Link to comment
Share on other sites

Guest Peterpools

Hi Mark

Terrific  choice for another NMF/Foil project. I have the same kit pretty much ready to go and will be using the AMS cockpit set. I was going to jump back into my Sufa project but might join you if you don't mind after I finish Duchess Arlene.

Keep 'em coming

Peter

Link to comment
Share on other sites

Beauty mark! I'll join you on your next foil adventure with my mustang :)

 

I will looking forard to your foil work.

Hi Mark

Terrific  choice for another NMF/Foil project. I have the same kit pretty much ready to go and will be using the AMS cockpit set. I was going to jump back into my Sufa project but might join you if you don't mind after I finish Duchess Arlene.

Keep 'em coming

Peter

 

Lets go Peter jump in maybe i can steel some idees from u ;)

careful around the rudder.......Mine was a bit to talll and too thick.....In hind site I should have glued the rudder half to each fuselage side.....now about those skyblazer decals.......

 

 

Rob

 

Thanks for the heads up and if u whant those decals sent me a pm and the are ours

Nice choice, Mark.

 

Still need to tackle a big sabre as well… too many ideas.. too many dreams… to little time….

 

Keep the mojo going….. :popcorn:

i know that feeling :hmmm:

 

Mark

Link to comment
Share on other sites

Terrific!

 

I also built same kit OOB and I can tell you, that careful dry fitting and reinforcement helps many fitting issues (still you need some putty, because of soft edges & moldings).

In Stash I have another kit with full aftermarket sets. I'm looking your WIP forward...!  :popcorn:

Link to comment
Share on other sites

Thanks for all the intrest in this one.

I made a start on the airbrakes and the fit whas good after a lot of dry fitting.

The plastic of the kit is thick.

The left side before(in the kit)

BILD3465_zps21f36872.jpg

 

Aires.

BILD3466_zps3999197c.jpg

 

Right side from the kit.

BILD3469_zps4fa71489.jpg

 

And the aires ones.

BILD3470_zpsa562426e.jpg

 

So far the fit is good.

Next up painting the air brakes

 

Mark

Link to comment
Share on other sites

Guest Peterpools

Mark

Nice start on the Sabre and no doubt in my mine, the air brake reto fit is the hardest oof all the resin to fit. terrific job on a difficult operation.

Peter

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...